Roller Shutter Tubular Motor Manufacturer Introduces The Troubleshooting Details Of Motor Faults


Posted February 23, 2021 by wistarmotor

Roller Shutter Tubular Motor Manufacturer teaches you how to check motor faults correctly:
 
Roller Shutter Tubular Motor Manufacturer teaches you how to check motor faults correctly:

1. Internal inspection process:


① Check whether there are cracks in the base and end cover and whether there are cracks or bending deformation of the rotating shaft.


②Check whether the rotor rotates flexibly and smoothly, whether the axial direction is floating, and whether there is any abnormal sound.


③Check whether the bearing is loose or stuck.


④Check whether the air duct is blocked, and whether the fan blades and heat sinks are in good condition.


⑤For motors with larger capacity, there are generally air gap holes on the end cover, and the average value of the air gap unevenness can be checked through the air gap holes to check whether the average value of the air gap is within 15%.


⑥Electrically run, and check whether the motor is normal by touching hearing nose, and eye. Once an abnormality is found, the power supply should be cut off immediately to prevent the fault from expanding.


2. For the mechanical parts in the motor, the following inspections should be carried out:


① Check for scratches on the surface of the stator and rotor cores. When there is only one scratch on the surface of the rotor but all scratches on the surface of the stator are caused by the bending of the shaft or the imbalance of the rotor; when there is only one scratch on the surface of the stator and scratches on the surface of the rotor, it is a constant The rotor is not concentric, such as the deformation of the base and end cover or the severe wear of the bearing that causes the rotor to sink; if the stator and rotor surfaces have large area scratches, it is caused by the above two reasons.


②Check whether the stator and rotor cores are aligned. If it is not aligned, it is equivalent to shortening the iron core, and the magnetic flux density increases, and the iron core is overheated. The reason is that the rotor core is axially displaced or the replacement of a new rotor is inappropriate. Also, check whether the stator and rotor cores move in the circumferential direction. If there is movement, it means that the screws that fasten the stator are loose or damaged or lost, or the rotor core and the shaft are not tightly matched.


③Check whether the rotor end ring is cracked or broken, whether the fan blade is damaged or deformed, and whether the rotating shaft is bent.


④Check whether the fit between the inner and outer shell of the bearing, the journal, and the bearing chamber meets the requirements, and whether there is too tight or too loose; check the degree of bearing wear, whether the bearing is intact and whether the lubricating oil (grease) is too little or dry.

Through the above introduction,Roller Blinds Motor Manufacturers hopes that you can simply refer to the content of this article in future use.

https://www.wistarmotor.com/
-- END ---
Contact Email [email protected]
Issued By wistarmotor
Country China
Categories Accounting , Affiliate Program , Architecture
Last Updated February 23, 2021