Plywood, wood, MDF, laser cutting is a complicated process and the selection of the process parameters combinations is essential to get the highest quality cut section.
Our Co2 laser cutting machine is a good tools for wood cutting and engraving.
CO2 laser cutting machine is a good tool that can be used to cut timber, Plywood, die board, and MDF panels. The wood laser cutting factors are: laser power, cutting speed, air pressure and focal point position.
In the wood laser cutting, cutting quality was evaluated by measuring the upper kerf width, the lower kerf width, the ratio between the upper kerf width to the lower kerf width, the cut section roughness and the operating cost. The effect of each factor on the quality measures was determined. The optimal cutting combinations were presented in favours of high quality process output and in favours of low cutting cost.
Take this plywood laser cutting machine as a case:
the upper kerf width is same with the lower kerf width, and it can cut all kinds of kerf width without stopping machine for the next kerf width adjustment.
For MDF laser cutting machine, the work will be easier than plywood laser cutting.