Awning Motors Manufacturers introduces the skills of installing tubular motor rolling doors:

1. First draw a line at the position of the door frame to be installed. Indicate the size, and then find the staff to design a suitable electric rolling door. It is worth noting that the height of the frame is a little higher than the height of the door leaf.

2. Then fix the door frame of the electric rolling door, here first remove the fixing plate at the lower part of the door frame. (Note: grooves should be reserved on the ground on both sides of the opening. After the correction is qualified, the wooden wedges, the iron feet of the door frame and the embedded iron plates should be welded firmly. Use cement mortar or the strength of not less than 10MPa, and the fine stone concrete should be firmly impacted That's it.

3. Install the main door leaf of the electric rolling shutter door leaf. It is necessary to ensure that the electric shutter door is integrated with the wall, and the sealing must be done well, and then paint the opening and the wall. After painting, the seam of the door should be even and flat, and the electric rolling door should be free and light to open, and there should be no over-tightening, over-looseness and rebound phenomenon.

Through the above introduction, Alexa Controlled Blinds Manufacturers hopes that you can simply refer to the content of this article in future use.

https://www.wistarmotor.com/