Float Pontoon Manufacturers introduced that the use of anchor chains is not based on the number of years, but according to the degree of wear to confirm whether it needs to be replaced. More than 1/3 of the chain links of the same anchor chain have obvious elongation, and the deformation and wear amount reaches 10% of the original diameter. After the anchor chain is severely worn, the new sprocket and the new chain should be replaced to ensure good meshing. You can't just replace the new chain or the new sprocket. At the same time, the end of the anchor chain and the commonly used end should be changed in a planned way after one or two years of use. In addition, special attention should be paid to that the old chain of the anchor chain cannot be mixed with part of the new chain, otherwise it is easy to have an impact during the transmission process, and the chain will be broken.

Pay attention to the maintenance of the anchor chain during use. When the anchor is dropped, the anchor chain must not be stopped when it is dropped. When the anchor is lifted, the anchor chain must be rinsed to remove debris and other debris; usually keep the anchor chain Dry, do not flush water into the chain cabin when washing the deck; check once every six months, arrange all the chain cables on the deck for rust removal, painting and inspection, and keep the signs clearly visible; when the chain is in use, Fill the lubricating oil in time, and the lubricating oil must enter the matching gap between the roller and the inner sleeve in order to improve working conditions and reduce wear.

Through the above introduction, Jet Ski Dock Manufacturers hopes that you can simply refer to the content of this article in future use.