The reasons for your heating failure can often be identified by its symptoms. To make it easier for you, here are a number of symptoms and appropriate solutions. The Central Heating Services Wanganui offers the best solutions there.
Heating does not start

If your radiators remain completely cold, this can have different causes.
Low fuel level: Check the amount of fuel in the tank of your heating system. Below a certain filling level, the heating no longer works.

Low water pressure: When the pressure in the heating system is too low, it stops automatically. If the pressure is too low, top up the heating water with demineralized water until a pressure between 1.2 and 1.8 bar is obtained. Your installer can give you the exact value.

Incorrect thermostat setting: Check that the heating thermostat is open and set to the correct temperature.

Circulation pump check: Check that the circulation pump warning light is on, and that the heating water is therefore pumped into the heating circuit. If this is not the case and the pump still does not work, you should call a technician.

Incorrect heating setting: In particular at the start of the heating season, your heating can still operate in summer mode and is therefore not ready for cold days. Simply switch the mode to your regulator and your heating should work again.

Valves seize: After a long heating pause, the valves may seize and the flow of heating water can no longer be adjusted. If, after turning the valve knob (thermostat), the temperature still does not increase, you should report a valve problem to your heating installer.

Heating does not heat properly

If your heating system only heats in places, such as upstairs, or does not heat properly, one of the most common reasons is that too much air is in the heating system. heater. The simplest solution to this problem is to bleed the heater, which you can do yourself using our instructions to bleed a heater where everything is explained simply. Another reason may be an imbalance in the pressure ratio in the system.

In this case, it is advisable to contact your heating installer and perform a hydraulic adjustment. This not only allows you to heat again, but also increases the efficiency of your heating system and reduces costs.

Heating makes noises

Even if the heating system heats up as desired, annoying noises can affect living comfort. Here, too, there are a series of symptoms and causes.

Gargoyle, lapping or gurgling heating

When the thermostatic valve of your radiator opens, it is normal for it to start gurgling or lapping when the water flows out. If these noises occur too frequently, there is usually too much air in the radiators and you should purge them. You can do this very simply yourself using our purge instructions , without the help of a specialist.

About the Company: Gas and heating services in New Zealand zone have been advancing the finest options for the central heating service. They have all the required settings for the same. Meanwhile, they have invigorated their base as well.